Nothing Comes Close

  • SCTRAILERS
  • SCTRAILERS
  • SCTRAILERS

2023 SCTrailers SCTrailers

  • VATT
  • VATT
  • VATT

2023 SCTrailers SCTrailers  Price: Call For Price

Details

Location
Kannapolis, North Carolina 
Make
SCTrailers 
Model
SCTrailers 
Price
CALL FOR PRICE 
VIN #
 
Exterior Color
WHITE 

Comments

SCTrailers Enclosed Bumper Pull WORK STATION Trailer

*19ft on the floor, 8ft wide, 7ft tall
*Full aluminum construction
*Single piece aluminum roof
*1-1/2" x 2-1/2 tubular wall framing
*Extruded aluminum floor
*White exterior, with stainless steel trim
*2 x 6,000lb torsion axles, with self-adjusting electric brakes----These axles will bolt in directly from manufacturer--NOT modified as your current trailer
*Axles will be mounted to a full width tubular structural steel sub-frame, rubberized coated, and held in place with 56,000lb 3/8" dia HUCK bolts
*5 x ST235/85R16E Tires—nitrogen filled, on 8 LUG aluminum wheels
*Spare tire will be mounted in front compressor cabinet, with "TRAILER HELPER" jack and lug nut brace
*2 -5/16" coupler on SHOCKER HITCH 20,000lb Air Coupler, with adjustable height channel
*2 x 16,200lb safety chains
*7 pin RV style electrical connector, with convenient 7 pin junction box
*Charging break away system, with LED charge indicator lamps
*LED running lights, including dual tail lights ( all lights are common ground lights)
*8,000lb side wind manual jack, with drop leg
*10,000lb scissor lift stabilizing jack mounted on each corner, with handle
*Walls and ceiling fully insulated, and lined with aluminum sheeting
*Felt back rubber coin flooring throughout
*Double rear doors, with aluminum cam lock bars on vice lock latches, with SCT HD full swing 12" hinges
*42" wide flip out aluminum step
*48" flip up rain / shade roof, on gas struts, with E-Z latch system to easily lock to rear doors
*2 x LED work lights located under shade roof
*Wireless monitor camera, mounted on rear of trailer OR under shade roof, with 7" monitor mounted in front control room
* LAMPHUS LED multi diode traffic adviser / direction indicator light bar---38" long 32 watt , mounted on rear roof top, with programmable controller mounted in work room
*120" rear work room, with white walls and ceiling
*4 x SUPA BRITE LED interior light in ceiling
*Flooring re-enforced with 3/8" aluminum plate, for crane
*Mount customer supplied crane, including wiring and 12 volt deep cycle battery in vented battery compartment (total of 3 x batteries)--with 3 x separate master switches, 12 volt diodes on each charge wire, preventing auxiliary discharge.
*Fabricate fully tig welded aluminum reel stand, complete with slide out drip tray and 500lb rated 48" deep lock in/ lock out storage compartment for robot storage.. Stand mounting will include additional sub floor reinforcement, and mounting of customer supplied reel
* MODULINE PROII SERIES cabinet package, white in color, mounted to the curbside in work room, Military grade aluminum with clear anodized coating ---consisting of
- 5 draw "QUICKDRAW" tool box 30" wide
-base cabinets with shelf
-75" tall locker, with shelf and clothes rod
-78" "Butcher Block" work bench
-Mirror stainless steel back sheet
-48" wide overhead cabinets, with gas strut flip up doors
*1 x SUPA BRITE LED light mounted under overhead cabinets / over workbench
* 2 x 110 volt 10 amp receptacles with stainless steel face plates @ workbench
*1 x 12 volt charging station @ workbench
*1 x BNC cable from control room to monitor location @ rear of overhead cabinets
*20 gallon fresh water tank, with external fill,
*12 volt / 55psi on demand water pump, with spigot outlet to rear of workbench cabinets
*2" wire race with removable cover to drivers side wall, from control room desk to crane area.
*1 x FLETTNER wind powered weather proof roof vent, with fresh air inlet to lower drivers side wall
*4 x billet aluminum recessed tie down D rings in floor - between MODULINE cabinets and reel stand
*Fully insulated and lined wall between work room and control room
*Sealed personal access door , with lockable paddle latch and tinted window
*Control room lined with black aluminum sheeting
*4" thick sound barrier wall between control room and compressor compartment
*Fabricated entry door, with "Kwikee" single electric access step
*50 amp service panel, with built in 12 volt charging
*13,500 BTU Dometic roof top AC unit
*5,000 BTU electric wall heater
*2 draw MODULINE file cabinet- with upper pencil draw---black
*48" MODULINE overhead cabinets, with gas strut flip up doors ---black
*Laminated work desk, with raised hutch to accommodate customers robot controls
*2 x 110 volt 10 amp outlets above desk, with one outlet below desk, all with stainless steel face plates
*1 x 12 volt charging station above work desk
*2 x SUPA BRITE LED ceiling lights, with switch @ entry door and work desk
* LED Blue courtesy lights, installed in non direct locations, with switch @ work desk
*BOSS radio/ CD system, Bluetooth/ MP3 compatible, with speaker in both work room and control room (includes remote control)
*5.5KVA Cummins Onan Quiet Gas commercial generator, mounted in separate fully welded / insulated compartment, with exterior louvered compartment door. 20-gallon sub floor fuel cell, with remote start panel including lighted fuel gauge and digital hour meter in control room. Padded / secured seat pad on compartment, providing comfortable seating in control room.
*built in 50 amp transfer switch (automatically switch between shore power and generator)
*50 amp exterior inlet, and 50 amp shore cord,
*2.7 cubic ft 110 volt mini fridge--black in color, mounted in recessed area in front wall
*10 amp GO POWER solar panel to rooftop, with control panel located in control room
*Hard wired Carbon dioxide alarm
*Fire extinguisher---mounted
*GFI 110 volt 10 amp exterior outlet to RHS of entry door.
*Front compressor compartment, with double access doors with aluminum cam lock bars and vice lock latches. Doors fully louvered. Roof of compressor cabinet fully louvered, allowing both heat and noise to escape, and allowing fresh air cooling. Spare tire will be mounted in the compressor room
* Mount customer supplied VANAIR Gas powered compressor, on 720lb rated vibration isolator mounts. Includes gas lines and secondary 12 volt fuel pump.

Features / Equipments

1GeneratorRefrigeratorAMFM CD Stereo