Comments

CUSTOM MADE------UTV/ Dog Bumper Pull Trailer
*25ft on the floor, 8ft wide
*Full aluminum construction
*2 x 10,000 lb Safety chains
*2-5/16" coupler
*2 x 5,200lb EZ Lube rubber torsion axles (Zero degree)
*4 x wheel self-adjusting electric brakes
*5 x ST235/80R16 tires, on aluminum split spoke wheels--Nitrogen filled
*7 pin RV style electrical connector
*Manual pipe mounted jack , with removable foot
*LED clear lens running lings
*Charging break away system, with LED charge indicator lamps
*Extruded aluminum floor
*Full tubular rear ramp
*14'6" UTV deck, with winch lash point at front
*16 x dog compartments approximately 24 x 24 x 45, solid rod doors, rubber mats, urine/wash out drains , spring latches, walk on roof with 6" tall tie rail to perimeter. *Exterior walls and roof fully insulated and lined, add 8" breezeway to top of dog compartments, with louvers each end, access ladder to roof located on front curb side
*Large 94" x 24" x 48" insulated and lined storage compartment directly behind dog compartments, with lockable sealed doors both sides, LED interior lights.
*6 x aluminum hooks each side, to hang leash and training collars ect.
*1 x aluminum tray on inside of each door, clothes rod in ceiling, and flettner wind powered weather proof roof vent.
*70-gallon water storage, with on demand 12-volt pump and spigot. Gravity tank drain valve, in base of large storage compartment
*12-volt deep cycle on board battery, to run water pump and work lights, even when not hooked to tow vehicle
*2 x insulated and lined storage compartments each side of UTV deck, each with lockable sealed doors and LED interior lights, Total of 8 x LED exterior porch lights---for safe night time operation. Aluminum storage box on from A frame.