Comments

CUSTOM MADE--------UTV/ Dog Bumper Pull Trailer 25ft on the floor, 8ft wide, Full aluminum construction, 2 x 10,000 lb Safety chains, 2-5/16" coupler, 2 x 5,200lb EZ Lube rubber torsion axles (Zero degree), 4 x wheel self-adjusting electric brakes, 5 x ST235/80R16 tires, on aluminum split spoke wheels--Nitrogen filled, 7 pin RV style electrical connector, manual pipe mounted jack , with removable foot, LED clear lens running lings, Charging break away system, with LED charge indicator lamps, extruded aluminum floor, Full tubular rear ramp, 14'6" UTV deck, with winch lash point at front, 16 x dog compartments approximately 24 x 24 x 45, solid rod doors, rubber mats, urine/wash out drains , spring latches, walk on roof with 6" tall tie rail to perimeter. Exterior walls and roof fully insulated and lined, add 8" breezeway to top of dog compartments, with louvers each end, access ladder to roof located on front curb side, Large 94" x 24" x 48" insulated and lined storage compartment directly behind dog compartments, with lockable sealed doors both sides, LED interior lights. 6 x aluminum hooks each side, to hang leash and training collars ect. 1 x aluminum tray on inside of each door, clothes rod in ceiling, and Flettner wind powered weather proof roof vent. 70-gallon water storage, with on demand 12-volt pump and spigot. Gravity tank drain valve, in base of large storage compartment, 12-volt deep cycle on board battery, to run water pump and work lights, even when not hooked to tow vehicle, 2 x insulated and lined storage compartments each side of UTV deck, each with lockable sealed doors and LED interior lights, Total of 8 x LED exterior porch lights---for safe night time operation. Aluminum storage box on from A frame.